How I sharpen small blades with a lansky honing system. I use the tormek small knife holding jig. : r/knifemaking

How I sharpen small blades with a lansky honing system. I use the tormek small knife holding jig. : r/knifemaking

I bought a skate sharpener. : r/hockeyplayers

Signal mod - knifeless version with a Swisscard scissor and bit holder with the T10 bit used to disassemble. : r/Leatherman

Sharpening Thread - Scrap Yard Discussion Forums

Tormek Knife Jigs - Lee Valley Tools

The Tormek Small Knife Holder SVM-00 can handle those really small knife blades which up until now have been difficult to sharpen. In the past they have been sharpened free-hand but every time it was a challenge to get a consistent shape and almost impossible to control the edge angle. You can now sharpen knives of different shapes for whittling, chip carving and detail work. Even folding pocket knives can be sharpened with perfect control.

Tormek SVM-00 Small Knife Holder Jig

Is it plausible to try and sharpen a small hatchet with sandpaper (80 grit and 120 grit) and finish of with a 600/800 stone? It's a cheap hatchet, so I would'nt wanna

How to sharpen a pocket knife with sandpaper - Quora

These jigs are compatible with the Tormek sharpening system. , Suitable for knife and drawknife blades from 2 3/8 long up to approximately 6 1/4,

Tormek Knife Jigs

The Best Knife Sharpener For Your Money

Knife Making Tools Jantz Supply - Quality Knifemaking Since 1966

This knife jig is designed in interface with the Sorby ProEdge Sharpening System This knife jig consists of a back plate, raised wear plate, universal

Robert Sorby #WPEKJIGS Proedge Knife Sharpening Jig Small for Knives Less Than 8 Inches Long

Handle for Lansky knife sharpening system by blecheimer - Thingiverse